CAT 627G Dokumentacja Strona 50

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 77
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 49
146 SEBU7858-03
Maintenance Section
Fuel System Primary Filter (Water Separator) Element - Replace
2. Push the switch
to the ON position in order to
pump the fuel.
Note: If the pu
mp will not pump fuel, the pump may
be faulty or an air leak may occur on the suction side
of the fuel system.
3. Continue to prime the fuel system until the ow
of fuel is free of air bubbles. Fuel should ow
continuous
ly from the drain hose.
4. After air has been purged from the fuel system,
close the pu
rge valve.
5. PushtheswitchtotheONpositionfor
approxima
tely 30 seconds in order to pressurize
the fuel system.
6. Start the e
ngine. If the engine will not start, further
priming is necessary. If the engine starts but the
engine continues to misre, further priming is
necessar
y. If the engine starts but the engine
continues to emit smoke, further priming is
necessary.
7. If the engine starts but the engine runs rough,
continue to run the engine at low idle until the
engine r
uns smoothly.
i02225257
Fuel System Primary Filter
(Water Separator) Element -
Replace
SMCS Code: 1260-510; 1263-070
NOTICE
Care must be taken to ensure that uids are contained
duri
ng performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the uid with suitable containers before open-
ing
any compartment or disassembling any compo-
nent containing uids.
Ref
er to Special Publication, NENG2500, “Caterpillar
Tools and Shop Products Guide” for tools and supplies
suitable to collect and contain uids on Caterpillar
pr
oducts.
Dispose of all uids according to local regulations and
ma
ndates.
NOTICE
Do not ll fuel lters with fuel before installing them.
Contaminated fuel will cause accelerated wear to fuel
systemparts.Fuelsystemshouldbeprimedpriorto
starting the engine.
Procedure for the Tractor
g01115383
Illustration 196
The primary fuel lter for the tractor is mounted on
the front of the hydraulic tank. The primary fuel
lter is on the right side of the engine compartment
underneath the hood.
1. Park the machine on a level surface.
2. Lower the bowl.
3. Shut off the engine.
4. Move fuel shutoff valve (4) to the CLOSED
position.
5. Clean primary fuel lter (2). Clean lter mounting
base (1), which is located above the lter.
6. Turn the lter to the left in order to loosen the lter.
Loosen the lter with a strap type wrench.
7. Remove the lter. Clean the bottom of the lter
mounting base. Make sure that all of the old lter
seal is removed.
8. Remove water separator bowl (3) from fuel lter
(2). Clean the water separator bowl and clean the
groove for the O-ring.
Note: Check the water separator bowl for damage.
Reuse the water separator bowl if no damage is
present.
Przeglądanie stron 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 76 77

Komentarze do niniejszej Instrukcji

Brak uwag